Press "Enter" to skip to content

Advances in Ceramic Armor VIII

The manuscripts contained during this factor of Ceramic Engineering and technological know-how complaints have been chosen from one of the greater than seventy shows on the Armor Ceramics Symposium. The discussions are divided into 3 sections: Modeling and dynamic habit, obvious fabrics, and Opaque fabrics. carried out in the course of the 36th annual foreign convention on complicated Ceramics and Composites (ICACC), this occasion is likely one of the optimal international meetings for the newest advancements within the fabrication, characterization, and alertness of ceramic fabrics to satisfy the desires of the army, police, and different public security, protection, and security organizations.

Content:

Show description

Read or Download Advances in Ceramic Armor VIII PDF

Best international books

Spatial Information Theory. Foundations of Geographic Information Science: International Conference, COSIT 2003, Kartause Ittingen, Switzerland, September 24-28, 2003. Proceedings

COSIT,theseriesofConferencesonSpatialInformationTheory,hasbeenaround for greater than ten years. Its hallmarks are a fruitful interdisciplinary discussion among computational and human views on spatio-temporal details and an intensive evaluation procedure that selects the simplest papers whereas giving all - thors special suggestions on the right way to increase their paintings.

Advances in Thermal Spraying. Proceedings of the Eleventh International Thermal Spraying Conference, Montreal, Canada September 8–12, 1986

Advances in Thermal Spraying includes the court cases of the 11th foreign Thermal Spraying convention held in Montreal, Canada, on September 8-12, 1986. The papers discover technological advances in thermal spraying and the similar box of surfacing through welding. This ebook is made from ninety seven chapters divided into sixteen sections and starts off with a dialogue at the functions of thermal spraying within the strength iteration undefined, with emphasis at the use of thermal coatings to guard boilers opposed to corrosion.

Additional resources for Advances in Ceramic Armor VIII

Sample text

Y0 determined from the Borofloat experiments (38 MPa) was used for the soda-lime simulations. The numerical Advances in Ceramic Armor VIII · 27 Constitutive Characterization and Simulations of Penetration into Thick Glass Targets results are shown as the solid lines in Figs. 9 and 10. Agreement with the experimental data is quite good. 70-km/s impact, where the simulations overpredict the eroded length by approximately 2 mm. Again, parametric studies on the influence of the constitutive parameters for the glass were conducted.

The confinement pressure for each test is shown. Figure 4. Representative Starphire specimen following triaxial compression. The arrow highlights the primary shear failure plane. Confined sleeve experiments were also conducted on predamaged specimens; the specimens were subjected to a maximum of 7 load cycles. The results for a multi-load test (5 load cycles) are shown in Fig. 5, where the data are plotted in terms of equivalent stress versus hydrostatic pressure. Hoop strain was measured with a strain gage mounted on the exterior of the confining sleeve.

21(1): 31-48 (1986). 25 1. Rohr, H. Nähme, K. Thoma, and C. E. , Material characterization and constitutive modeling of a tungsten-sintered alloy for a wide range of strain rates, Int. J. , 35(8): 661673 (2008). V. Hohler and A. J. Stilp, Visualization of the penetration process of rods into glass and armor steel targets by means of flash X-ray photographs, 35' Mtg. Aeroballistic Range Assoc, Meppen, Germany, Sept. (1984); personal communication with C. E. Anderson, Jr. (1993). 27 T. J. Holmquist, G.

Download PDF sample

Rated 4.00 of 5 – based on 15 votes